14
EN
Operation
1
Make sure that the power cord is not wrapped around the machine before
commissioning.
2
Connect the power cord to a 230 V/50 Hz electrical outlet.
3
Turn on the device by pressing and holding the ON/OFF switch for about 2
seconds.
4
Use the +/- buttons to set the desired temperature setting and place the device
on a heat-resistant surface until it is warm.
During warm-up, 0 to 5 indicators will blink on the temperature LED until the
desired temperature is reached.
When the device reaches the desired temperature, the flashing stops and
only the appropriate number of indicators (1 - 5) are lit according to the set
temperature.
5
Turbo mode
Activation: Pressing the “+” button for approx. 2 seconds increases the
temperature to a maximum of 230 ° C.
Deactivation: Press “-” to decrease the temperature as in normal mode.
Thermal lock:
To activate: Press the ON/OFF switch twice.
All buttons will be locked and the lock symbol will be displayed. Deactivation:
Press the ON/OFF switch twice again. All buttons are unlocked and the lock
symbol disappears.
6
After the desired temperature has been set, the device is ready for use in
about 15 seconds, when the temperature is reached and the corresponding
indicators remain lit. Use the device for up to 20 minutes at a time.
Then turn off the device for at least 15 minutes.
Straightening (ironing) of hair
The hair must be washed, thoroughly dried and combed before treatment. Do not
use any hair care products.
You can only use a special spray to protect your hair from burning.
1
Plug the iron into a power outlet and turn it on by pressing and holding the ON/
OFF switch for about 2 seconds. The LED indicators will flash.
2
Adjust the temperature using the +/- buttons.
All LED indicators will flash sequentially and when the desired temperature is
reached, the appropriate number of indicators will light and the iron will beep.
3
Comb the hair thoroughly.
4
Open the plates
5
Place a wide strand of hair between the ceramic plates
If you have thick hair, divide it into smaller strands using hair clips. Gently
squeeze the plates, wait for 2-3 seconds and slowly and evenly move the
device from the roots to the ends of your hair. Depending on the length of the
hair, however, this must not exceed 5 to 8 seconds, maximum 10 seconds.
.
