15
EN
Preparation and operation
Unpack the unit, make sure it is not damaged and remove any
packaging material from it.
Requirements for connection to the grid
• Before connecting the appliance to the power supply, make sure
that the mains voltage in the electrical network corresponds to
the data shown on the nameplate located on the bottom of the
electrical base and the kettle.
• The appliance must only be connected to a 230 V ~, 50 Hz power
socket.
Before using the boiled water for the first time, you must at least 3
times boil t the water, pour it and thoroughly rinse the kettle. Pour
the water over the maximum level inside the kettle.
1
Unscrew the power cord from the base unit. Place the device on a
flat, stable surface.
2
Fill the kettle with a suitable amount of water. Please follow
the MAX pointer. Close lid, otherwise the kettle does not
automatically shut off after water tapping and water can drain
from the kettle.
Warning !:
The water level must be at most MAX. (1.7 l) on the
dispenser. Too little water can cause damage to the heater and
too much water can cause the water to drain.
3
Connect the base to the mains. Put the kettle on the power base.
Put the kettle in such a way that it is directed from you.
After putting the kettle on the base, the kettle is ready for
operation.
4
Switch the kettle on by switching the
(6)
0/I switch to I (On).
WARNING!
Never fill the kettle when it is placed on the pedestal.
If the kettle is full, the boiling water may splash out. Do not run
the kettle. Improper use of the kettle can adversely affect its
service life. If you accidentally switch on the kettle without water,
the thermostat switches off automatically when it reaches a
certain temperature. switch
(6)
switches to position 0 (off) and the
indicator light goes out. The kettle can be restarted after a few
minutes as soon as the anti-corrosion floor cools down.
