Preparation and operation
Unpack the unit, make sure it is not damaged and remove any packaging
material from it.
Requirements for connection to the grid
• Before connecting the appliance to the power supply, make sure that the
mains voltage in the electrical network corresponds to the data shown on
the nameplate located on the bottom of the electrical base and the kettle.
• The appliance must only be connected to a 230 V ~, 50 Hz power socket.
Before using the boiled water for the first time, you must at least 3 times
boil t the water, pour it and thoroughly rinse the kettle. Pour the water over
the maximum level inside the kettle.
1
Unscrew the power cord from the base unit. Place the device on a flat,
stable surface.
2
Fill the kettle with a suitable amount of water. Please follow the MAX
pointer. Close lid, otherwise the kettle does not automatically shut off after
water tapping and water can drain from the kettle.
Warning !:
The water level must be at most MAX. (1.7 l) on the dispenser.
Too little water can cause damage to the heater and too much water can
cause the water to drain.
3
Connect the base to the mains. Put the kettle on the power base. Put the
kettle in such a way that it is directed from you.
After putting the kettle on the base, the kettle is ready for operation.
4
Switch the kettle on by switching the
(6)
0/I switch to I (On).
WARNING!
Never fill the kettle when it is placed on the pedestal.
If the kettle is full, the boiling water may splash out. Do not run the kettle.
Improper use of the kettle can adversely affect its service life. If you
accidentally switch on the kettle without water, the thermostat switches off
automatically when it reaches a certain temperature. switch (5) switches to
position 0 (off) and the indicator light goes out. The kettle can be restarted
after a few minutes as soon as the anti-corrosion floor cools down.
12
EN
