14
EN
Preparation before use
Do not connect the appliance to the power supply during preparation.
Do not immerse the device in water! Clean the device surface with a cloth
dampened in water. Some impurities from the manufacturing process or
packaging material could remain on it.
Dry thoroughly after cleaning.
Commissioning
1.
Place the machine on a horizontal, stable, non-flammable, heat-resistant
surface. There must be nothing placed around the device and above the
device.
2.
Set the temperature control knob to the OFF position.
3.
Connect the equipment to the mains.
4.
Place a metal cooking pot on the electric heating plate that is flat and stable
and cannot tip over. Fill the container with cooked food (liquid, etc.).
Note:
Use dishes with a flat (ground) bottom of the same or larger (max. 4
cm) diameter as the plate to treat the dishes. If the bottom is not flat, there
is no optimal heat transfer from the plate to the dishes, thus increasing the
power consumption and the cooking time increases.
5.
Use the power adjustment knob to adjust the power from 1 (lowest
temperature) to 5 (maximum temperature). The electric heater plate will be
switched on and off alternately to maintain the set temperature as indicated
by the indicator light.
Note:
The electric heater plate will start immediately after setting the
temperature controller heating up. Do not touch it or other parts of the area
and the cooking utensil.
Risk of burns! In the very first heating after purchase, the spread of mild
smoke and odor may occur. It is a common process for firing electric
heating plates. It is not a malfunction and there is no danger to health.
6.
When cooking is complete, set the temperature control knob to the left of
the OFF position.
Unplug the appliance and do not touch it until all parts have cooled down.
Equipment cleaning and maintenance
Turn off the appliance, unplug the power cord, and allow it to cool completely
before cleaning.
Cleaning the surface of the device
• Never immerse the appliance in water or any other liquid!
• Use only a slightly damp cloth to clean the surface of the machine.
• Do not use any solvents or abrasive cleaners.
• After cleaning, wipe the device dry.
