6-2
TECHNICAL DATA
ORBAN MODEL 8300
Installation
Delay
Minimum Processing Delay:
Processing structure dependent. Typically 20 ms for optimum
5-band using “MX” presets, 15 ms for optimum 5-band using non-MX presets, 3.7 ms for
ultra-low-latency 5-band, and 17 or 22 ms for 2-band, depending on crossover structure
chosen.
Relative Delay Between HD and FM Analog Processing Chains:
Constant number of
samples. HD has approximately 3 ms longer delay than analog.
Analog Audio Input
Configuration:
Stereo.
Impedance:
>10k
load impedance, electronically balanced
1
.
Nominal Input Level:
Software adjustable from –4.0 to +13.0 dBu (VU).
Maximum Input Level:
+27 dBu.
Connectors:
Two XLR-type, female, EMI-suppressed. Pin 1 chassis ground, Pins 2 (+) and
3 electronically balanced, floating and symmetrical.
A/D Conversion:
24 bit 128x oversampled delta sigma converter with linear-phase anti-
aliasing filter. Converter outputs 64 kHz sample rate, which the 8300 then decimates to
32 kHz in DSP using an ultra-high-quality image-free synchronous sample rate con-
verter.
Filtering:
RFI filtered.
Analog Audio Output
Configuration:
Stereo. Flat or pre-emphasized (at 50
µ
s or 75
µ
s), software-selectable.
Source Impedance:
50
, electronically balanced and floating.
Load Impedance:
600
or greater, balanced or unbalanced. Termination not required or
recommended.
Output Level
(100% peak modulation): Adjustable from –6 dBu to +24 dBu peak, into 600
or greater load, software-adjustable.
Signal-to-Noise:
>= 90 dB unweighted (Bypass mode, de-emphasized, 20 Hz–15 kHz
bandwidth, referenced to 100% modulation).
L / R Crosstalk:
<= –70 dB, 20 Hz–15 kHz.
Distortion:
<= 0.01% THD (Bypass mode, de-emphasized) 20 Hz–15 kHz bandwidth.
Connectors:
Two XLR-type, male, EMI-suppressed. Pin 1 chassis ground, Pins 2 (+) and 3
electronically balanced, floating and symmetrical.
D/A Conversion:
24 bit 128x oversampled, with high-pass filter at 0.15 Hz (–3 dB).
Filtering:
RFI filtered.
Digital Audio Input
Configuration:
Stereo per AES3 standard, 24 bit resolution, software selection of stereo,
mono from left, mono from right or mono from sum.
1
No jumper selection available for 600
. Through-hole pads are available on I/O
module for user-installed 600
termination.
Summary of Contents for 8300J
