2-6
INSTALLATION
ORBAN MODEL
Connectors
•
Input and output connectors are XLR-type connectors.
In the XLR-type connectors, pin 1 is CHASSIS GROUND, while pin 2 and
pin 3 are a balanced, floating pair. This wiring scheme is compatible with
any studio-wiring standard: If pin 2 or 3 is considered LOW, the other pin
is automatically HIGH.
Analog Audio Input
•
Nominal input level between –14 dBu and +8 dBu will result in normal operation
of the 8500S.
(0 dBu = 0.775Vrms. For this application, the dBm @600
Ω
scale on volt-
meters can be read as if it were calibrated in dBu.)
•
The peak input level that causes overload is +27.0 dBu.
•
The electronically balanced input uses an ultra-low-noise-and-distortion differ-
ential amplifier for best common mode rejection, and is compatible with most
professional and semi-professional audio equipment, balanced or unbalanced,
having a source impedance of 600
Ω
or less. The input is EMI suppressed.
•
Input connections are the same whether the driving source is balanced or unbal-
anced.
•
Connect the red (or white) wire to the pin on the XLR-type connector (#2 or #3)
that is considered
H
IGH
by the standards of your organization. Connect the black
wire to the pin on the XLR-type connector (#3 or #2) that is considered
L
OW
by
the standards of your organization.
•
In low RF fields (like a studio site not co-located with an RF transmitter), connect
the cable shield at 8500S input only—it should not be connected at the source
end. In high RF fields (like a transmitter site), also connect the shield to pin 1 of
the male XLR-type connector at the 8500S input.
•
If the output of the driving unit is unbalanced and does not have separate
C
HASSIS
G
ROUND
and (–) (or
L
OW
) output terminals, connect both the shield and
the black wire to the common (–) or ground terminal of the driving unit.
Analog Audio Output
•
Electronically balanced and floating outputs simulate a true transformer output.
The source impedance is 50
Ω
. The output is capable of driving loads of 600
Ω
or
higher; the AO 100% control can adjust the 100% modulation level over a –6
dBu to +24 dBu range. The outputs are EMI suppressed.
Summary of Contents for OPTIMOD-FM 8500S
