ST 6100 Terminal Installation Guide
R9015 Version 03
8
© ORBCOMM
®
Proprietary
5)
Using a soldering iron and solder, tin the wires and solder them to the connector solder cups (Figure 14) as
per the proper pinout.
Figure 14 Wires and Solder Cups
6)
Ensure the O-ring is in place over the connector body.
Figure 15 O-Ring over Connector Body
7)
Slide the coupling ring over the connector body and give it a twist to prevent it from falling off.
8)
Use silicone sealant to completely fill the end of the connector and the area between the wires.
Figure 16 Silicone in the Connector
9)
Slide the back shell up the cable as close as possible to the connector body and fill it with silicone sealant.
Figure 17 Silicone in the Grommet