PWS 0547
15
ASSEMBLY INSTRUCTIONS
STAND FAN
To assemble the base and counterweight to the base, you must use the hemispherical metallic piece shown in
figure. Place the counterweight under the base and screw the screw. Then screw the support bar.
.
Insert the plastic part shown in the picture through the
upper part tube to hide the counterweight piece.
Insert the tube in the gap under the motor (check in
the picture). Unscrew the screw, put the tub inside, and
then screw firmly.
Connect the rear grille to the motor’s case and fix it
with the four screws.
Assemble the blades in the engine’s shaft. The
fastening screw should coincide with the shaft’s slot.
Connect the front grille and screw the grille’s fastening
screw. Then close the fastening clips.
