PWS 0547
18
Connect the rear grille to the motor’s case and fix it with the four
screws.
Assemble the blades in the engine’s shaft. The fastening screw should
coincide with the shaft’s slot.
Connect the front grille and screw the grille’s fastening screw.
Hang the fan up on the wall with the hooks.
Use the attached piece to put the remote controller.
OPERATING INSTRUCTIONS
1.
Please make sure the switch is in the off position. Then insert the power plug into the specified
voltage AC outlet on the date plate.
2.
The speed is adjusted by moving the knob to the desired setting. The numbers 0, 1, 2, 3 on the
board indicates off, slow, moderate and fast in the proper order. The speed of wall fan is
adjusted by speed wire switch.
3.
To set the fan into oscillation, depress the Oscillating knob on the top of the motor assembly.
The fan head will pivot side to side. For stationary operation, pull up the Oscillating knob. And
the wall fan oscillating is controlled by the oscillating wire switch.
4.
Table fan and wall fan adjust the tilt angle, loose the screw a litter, then adjust the angle to the
desired position, re-tighten the screws. The height of the stand fan is adjusted by adjusting the
height adjustment lock.
CLEANING/MAINTENANCE
Follow these instructions to correctly and safely care for your power fan.
Please remember:
•
Always unplug the fan before cleaning or disassembling.
•
Use a damp cloth to clean the dust from the device.
•
Do not allow water to drip on or into the fan motor housing.
•
Do not use any of the following as a cleaner: gasoline, thinner, or benzine.
