DS 61190 IN
15
9.
Open the aluminum filters and find 2 holes, mark on the wall. Remove the hood and drill 2 holes in last
marks. Put the drywall anchors into the holes, place the cooker hood in its place and screw the 2 screws
with their washer.
10.
Put the glass in the lead way, use four screws (4x25cm) with glass washer and rubber washer to fix the
glass. The screws and the washers should be installed as shown.
11.
Place the inner tube into the outer tube and screw the platen section as below picture shows. Then
place the tube on the cooker hood and adjust the inner tube to the height of U-shaped section and
screw the tube to the platen section.
Vent inside
If you do not have an outlet to the outside, the exhaust pipe is not required and the installation is similar to
the one shown in the “INSTALLATION (VENT OUTSIDE)” section but you have to install carbon filter (not
included) in the motor. To put the carbon filter, place on the side of motor and turn until fit it.
