CA 07260 A IN
13
2.
A straight, short duct run will allow the hood to perform most efficiently.
3.
Long duct runs, elbows and transitions will reduce the performance of the hood. Use as few of them as
possible. Larger ducting may be required for best performance with longer duct runs.
4.
The outside of the hood for the duct is 150mm. However we provide a reducer from 150mm to 120mm
to use a smaller duct of 120mm.
5.
The duct shouldn’t discharge into a flue for exhausting fumes from gas or other flues appliances.
ELECTRICAL CONNECTION
- Electric connection should be done by qualified person according current regulation. Disconnect main
power of house before connect the hood.
- If supplied cord is damage, should be replaced by the maker or technical service.
- Don’t use a plug or extension whose are not supplied with the hood.
INSTALLATION
The hood is designed to work with a duct of 150mm of diameter. If you use a 120mm duct place the
supplied reducer.
DUCT INSTALLATION
Use an outlet exhaust duct with: minimum indispensable length, minimum possible bends (maximum angle
90º), certified material and as smooth as possible inside.
FITTING HOOD TO FURNITURE
1.
Before attaching the hood to the cabinet, make a 165mm diameter hole for the 150mm or 135mm tube
for the 120mm tube.
2.
Make sure that the hole in the cabinet has the dimensions of the hood 490X258cm.
3.
In any case, check the position of the hood before installing it, so that it can be connected to the nearest
outlet without problems, in case you have to make a hole in the cabinet to pass the cable.
4.
Unscrew the visible screws located on each side of the hood and remove the front, 8 holes will be visible.
5.
Lift the hood and place it in its position in the cabinet. Fix the hood to the cabinet by screwing it through
the 8 holes mentioned above. Replace the front of the hood and fix it with its 2 corresponding screws.
6.
Make the electrical connection.
7.
The installation has been completed.
