13
WARNING: the lamp may be finished off with an outer glass lampshade instead. If the latter
gets broken or damaged, it must be replaced with another one which has to be the same
model. Contact your local dealer or point of sale where you purchased your ceiling fan to get
another glass lampshade.
REMOTE CONTROL
TRANSMITTER FUNCTIONS
FAN SPEED
: Push the corresponding button to select the desired speed: HIGH, MEDIUM, LOW,
to disconnect the fan or the lamp. To connect the lamp again, press the button again.
i
Replace worn-out batteries by sliding the battery compartment lid open in the
direction of the arrow. This remote control uses two AA batteries. Put them in
correctly, as indicated in the compartment (PLEASE NOTE: batteries are not included).
Replace the lid.
i
Always REMOVE all batteries at the same time. Never mix new batteries with old ones,
nor different brands of battery.
i
ALWAYS ensure the battery compartment is properly closed.
i
NEVER leave the remote control exposed to direct sunlight.
i
NEVER attempt to recharge normal batteries by heating them or using a battery
charger. Rechargeable batteries are always clearly marked as such.
i
NEVER throw batteries into the fire; they might explode.
INSTRUCTIONS FOR ELECTRICAL WIRING
TRANSMITTER OPERATION:
Point the remote at the infrared sensor to power the fan.
LIGHT ON: Make a short press to switch on the light.
LIGHT OFF: Make a short press to switch off the light
HI: Select high speed fan.
MED: Select medium speed fan.
LOW: Select low speed fan.
VENTILADOR OFF: Turn off the fan rotation.
INSTALLATION GUIDE:
WARNING: IMPROPER CONNECTION OF THE WIRES MAY DAMAGE THE RECEIVER.
1.
Connect the wires as shown in the illustrations (Fig. 1.1 y Fig. 1.2.) Place the infrared
sensor always out of the bezel. Its location will depend on the reception conditions.
(Fig. 2)
CP 68132
All manuals and user guides at all-guides.com
