PWS 2046
13
Fan base/Head assembly
Insert the shank into the base and fasten it with the four screws provided
Insert the plastic part shown in the picture in the upper part of the tube
to hide the counterweight piece.
Assembling the fan and the support bar
To connect the fan to the support bar, use the T-
shaped accessories as it is showed in the attached
picture.
Each T-shaped piece should be assembled in both sides
of the support bar. Match up the holes of the T-shaped
pieces and the holes of the support bars, and use the
screws and nuts. Screw them firmly.
OPERATING INSTRUCTIONS
Control panel
1.
Connect the power supply plug to a wall power outlet. You can now
operate the apparatus by means of the function keys on the switch box
or remote controller (if equipped).
2.
A change in the function is usually indicated by a beep.
3.
All function keys are enabled after switching on the ON/OFF switch
manually. When power is turned OFF, all settings (with the exception
of TIMER settings) are save in memory.
4.
A change in the function is usually indicated by a beep.
On/off switch
