SFA 7000
14
Assembling the rear guard
1. Take out the blade cap from the shaft turning it clockwise.
2. Take out the rear guard mounting nut turning it anti-clockwise.
3. Insert the rear guard into the motor matching 3 rods on the front side of the motor(the handle
will direct upwards) to 3 holes of the rear guard.
4. Fasten the rear guard tighly by turning the guard mounting nut clockwise.
Assembling the fan blade
1. Insert the blade to the motor shaft and ensure the pin enters the blade slot.
2. Tighten the blade using the blade cap turning anti-clockwise in the direction “TIGHTEN” arrow on
it.
Note: Proper assembly of the blade is of great importance. Otherwise, the blade spins in the air and
damage the appliance.
Assembling the front guard
1. Fix the front guard with the logo in the horizontal position on the rear guard. Make sure they are
connected from the upper side.
2. Take the front guard with guard ring to set in groove and fix it with screwdriver.
Note: Do not operate the fan without assembling the guards properly and tihgtly.
OPERATING THE WATER TANK
Position the fan on level floor and add distilled water inside the water tank according to six steps
below.
Note: Do not take out the water tank before unplugging the power cord plug. Hot water (40
℃
and
above) is not allowed to add in the water tank.
Open the water tank panel.
Lift the water tank flatly.
Take out the water tank flatly.
Put the water tank base
Screw of water tank
cover and add water
Screw tank cover TIGHTENly and
put it in to the fan and close the
