2. Turn on your computer and plug in the USB connector of
the USB-HS Serial Converter into the USB port.
3. If you have already installed a Modem device before, click
Start, Settings, and Modems. Open Modems Properties,
select the Modem, and click Properties. In General tab,
please change the
Port
value to
USB Serial Port (COM3)
.
4. After finishing these processes, you can use USB to Serial
Bridge Cable to connect RS232 Serial 56K FAX Modem and
execute the Dial-up function to connect Internet, and send the
FAX with the FAX software (ie: Microsoft FAX) properly.
Uninstalling the Driver Program
If you want to remove the USB-HS Serial Converter driver
program, you can uninstall it by following the steps below:
1.
Unplug the USB-HS Serial Converter from your PC.
2.
Run the
D:\Driver\Win98&win2000\FTDIUNIN.EXE
program from the software CD-ROM, Click finish then
reboot the PC.
Disclaimer
Information in this document is subject to change without
notice. The manufacturer does not make any representations
or warranties (implied or otherwise) regarding the accuracy
and completeness of this document and shall in no event be
liable for any loss of profit or any other commercial damage,
including but not limited to special, incidental, consequential,
or other damages. No part of this document may be
reproduced or transmitted in any form by any means,
electronic or mechanical, including photocopying, recording or
information recording and retrieval systems without the
express written permission of the manufacturer.
All brand names and product names used in this document
are trademarks, or registered trademarks of their respective
holders.
A016.70.56505
ORBIS TECNOLOGIA ELECTRICA, S.A.
Lérida, 61 E-28020 MADRID
Teléfono: +34 91 5672277; Fax: +34 91 5714006
E-mail: info@ orbis.es
http://www.orbis.es
