Orbit baby Base, Manual

30

30

30

30

31

31

31

31

1.  The Orbit Base should be installed 

without your Orbit carseat docked.  If 
attached, fi rst remove the Orbit carseat. 

2.  Check that the Base StrongArm is reset 

to zero (Photo A).  If not, then turn the 
StrongArm Knob counterclockwise until 
the zero is visible.

3.  Free the LATCH Connectors from their 

storage locations by pressing the red 
buttons and pulling them upwards at 
the same time.  For ease of installation, 
extend the LATCH Belt to its maximum 
length by pressing the grey tab on the 
adjuster and pulling on the belt (Photo 
B).

4.  Position the LATCH Belt through the 

Belt Guides as shown (Photo C).

5.  The LATCH Belt must be secured in 

place by the Lock-off Clamp.  If it is 
not:

-  Center the colored stitch line of 

the LATCH Belt in the middle of 
the Lock-Off Clamp (Photo D)

-  Close the Lock-Off Clamp and 

secure it fi rmly upon the LATCH 
Belt by fl ipping the top closure 
down into place.

6.  Place the Base in the vehicle seat 

(Photo E), making sure the areas under 
and behind the Base are clear of 
obstructions.

7.  If the vehicle seat back is adjustable, 

lock the vehicle seat back into the 
upright position.

 
8.  Attach both LATCH Connectors to their 

corresponding lower LATCH anchors.  
With the LATCH Connector oriented as 
shown (Photo F),  push it straight onto 
the metal bar until you hear and feel a 
CLICK.  

When using the LATCH system, the 
Orbit Base uses only the lower anchors.

Installing the Base: 
With LATCH System

Installing Y

our Orbit Base

Installing Y

our Orbit Base

A

B

C

D

E

F