9
7) Install the Left and Right Handlebar Tubes
Connect the hand pulse wire II (59) from the Left and Right
handlebar tubes (6, 20) with the hand pulse Wire I (58) from the
Seat cushion adjustor (4). Put the extra wires into the hole of the
Seat cushion adjustor (4). Attach the Left and Right handlebar tubes
(6, 20) to the Seat cushion adjustor (4) with four sets of M8*20
（
75
）
φ
8 spring washer
(74) and Arc washers (12). (See figure 7)
8) Adjust the Seat cushion frame
Release and pull the Stretching knob (32) and then insert the Seat cushion adjustor (4) into the tube of Main
Frame (30). Adjust the Seat cushion adjustor (4) to the desired hole for the appropriate position and tighten
the Stretching knob (32) after adjustment. (See figure 8)
(Note: Do not over the safety guiding line during adjust the Seat cushion tube)
9) Install the Left & Right Pedals
First install the two pieces of Pedal strip (66) on the Left & Right Pedals (51). Attach the Left & Right pedals
(51) to the Crank (29). The Left Pedal (51L) should be threaded on counter-clockwise. The Right Pedal (51R)
should be threaded on clockwise. (See figure 9)
NOTE:
The Left & Right Pedals (51)
are marked with “
L
” & “
R
”.
