7
5. Hardware Packing List
6. Assembly Instructions
1) Install the Front Stabilizer
Attach the Front stabilizer (27) to the Main frame (30) with two sets of M10*70 Bolt (21),
φ
10 Flat washers
(48),
φ
10 Spring washers (71) and M10 Cap nuts (3). (See figure 1)
2) Install the Rear Stabilizer
Attach the Rear stabilizer (28) to the Seat cushion adjustor (4) with two sets of M10*70 Bolt (21),
φ
10 Flat
washers (48),
φ
10 Spring washers (71) and M10 Cap nuts (3). (See figure 2)
3) Install the Front Upright Tube
a. Pull the Sensor wire (56), hand pulse wire 1 (58) out from the bottom hole of Front upright tube (46).
b. Connect the joint of the tension control (52) with the tension control wire (50) firmly. Note: at first, please
turn the tension control’s knob to the bottom of the “+” direction (in this situation, the joint of the tension
