Console Operation
34
5.
English and Metric setting
The factory default setting is English units. If you wish to change it to Metric setting, press & hold
“USER1” & “USER2” keys at the same time for a couple of seconds during idle mode. The message
the setting. “UNITS = METRIC” will appear to indicate the switch. Once you change the setting,
display will show a message “UNITS = ENGLISH”; press / keys on the LCD screen to change
press ENTER key to confrim and the console will return back to idle mode. The units setting has
been changed to new setting permanently.
6.
Touch Screen Adjusting Steps
To ensure touch screen console perform properly, please follow below steps to adjust the display
accuracy.
1) When the console is ON, the message display shows “SELECT A PROGRAM”; at this time
The LCD will be fully light up and the message display will show “PRESS ICON”. At this time,
press “QUICK START” & “HR PROGRAM” keys at the same time to
start the display adjusting
sequences.
2)
press “START” key to enter console self-adjusting mode.
3) Follow the key order and presses “PAUSE/RESET”, “ENTER”, “UP”, “DOWN” & “DISPLAY”
display shows “756” and “5” for “DESPLAY” key press; see figure 1 below.
keys. The message display will show corresponded number and key sequence. For example, the
4) After the key presses, press the “QUICK START” key,
the LCD will be fully lighted up, see figure 2
below.
5) Press “QUICK START” one more time after screen is completely light up to exist the self-adjusting
mode and back to idle mode.
6) Your screen is now adjusted properly and ready to use.
Figure 1
Figure 2
Summary of Contents for Raptor CDX
