21
4.2.2.2 SETTING THE DIGITAL FILTERS
+
CHA.
SER.
OUT.
SET
FIL.
FOR.
INP.
MOD
CON.
OFF
RND.
EXP.
DES.
FIL.
Setting the digital filters
CON.
Setting the filtration constant
- this menu is always displayed after selection
of a particular type of filter
OFF
Filters are off
EXP
Selection of exponential
filter
- the value is calculated from a number of
measurements selected in „CON“
- range 2…100
RND.
Rounding the measured
value
- it is set by an optional number which
determines the projection step
(e.g. step 2,5 - 0, 2.5, 5, 7.5, etc.)
4.2.2.3 SETTING THE DECIMAL POINT
DC
PM
DU
OHM
F
+
CHA.
SER.
OUT.
SET
FIL.
FOR.
INP.
000.
0.00
00.0
FL.P.
DES.
FOR.
Setting the decimal point
- the instrument allows classic projection of a
number with placement of the decimal point
as well as projection with floating point,
allowing to display the number in its most
precise form „FL.P.“
000.
Setting the DP
00.0
Setting the DP
0.00
Setting the DP
FL.P.
Setting the DP
4. INSTRUMENT SETTING - CONFIGURATION MODE
Summary of Contents for OMX 100 Series
