BROADBAND
I N N O VAT I O N
Ⅳ. Operation instructions
05
Always wear the appropriate PPE protection while using the unit
1. Set up.
a. Take the sprayer components out of the box and remove the individual parts
bags from inside the container
b. Select the appropriate nozzle size that you would like to use:
i. Ceramic Chip Applicator Nozzle-Very Fine Mist (shorter drying time)
ii. Other Nozzle- Medium - Heavy Mist
c. Place the tank filter into the hole in the bottom of the tank
d. Place the solution strainer in the top of the tank, fill with the appropriate
solution and replace the tank cover
e. Attach the battery and charge if necessary (see instructions below),
you can use the voltage gauge on the back of the tank to check the amount
of batter charge left.
This unit is equipped with a high capacity, DURACELL Ultra battery.
It is one of the best in class on the market with no memory effect,
stable performance and long-life cycle.
2. Charging.
a. First, Plug the charger into the charger hole at the base of the tank.
b. plug the other end of the cord into the 110V power outlet.
c. At this time, the charging indicator will be "red”.
d. When the indicator light turns "green", it indicates that charging is complete.
e. NOTE: the charging time can vary according to the amount of charge
remaining in the battery. A completely dead battery can take up to 4-6 hours
to completely recharge.