Operating instructions SCORP
6 Operation
orbitalum tools
gmbh
(06.07)
MT_SCORP_BA_04_790014762_09.doc
19
6.4
Straightness of cut and control wheel
The cut is affected by many factors, e.g. the size of the pipe, the material, the
wall thickness, the quality of the pipe's surface, the roundness, welded seams,
blade condition, feed rate, operator's experience. For this reason the result
may vary, and the cut may turn to left or right (misalignment of the cut's starting
and ending point).
The pipe saw gripper (1) has one adjustable wheel (2) which should be used
for improving the quality of the cut and for reducing the misalignment.
The adjustment applies only to the actual pipe size and material, and the wheel
may have to be readjusted as the blade is worn.
The wheel can be adjusted in 9 positions; mid position and 4 steps to left and
right (see picture below).
2
1
Summary of Contents for SCORP 220 Plus
Page 27: ......