OPERATION
Unpacking and Initial Operations
Open shipping box (both sides). Remove
packaging material and roll machine out of
box.
Pre-Run Inspection
Before each use, inspect for cracks, tears or
excess wear. If the machine or accessory is
dropped, inspect for damage. Then repair or
replace, if necessary, before use.
1 -
Tilt head back and place the foot of
bumper on the ground. Choose a pad for the
appropriate application.
2 -
Center the pad
on driver plate.
3 -
Then position handle in a
lower position.
4 -
Push slowly forward until
machine base tilts towards the ground.
CAUTION
Make sure to put the wheels back on the
ground in time to avoid the base from falling
on the ground. This might cause damage!
Check that the power switch is in the “off”
position.
Power Cable / Quick Disconnect
Take provided power cable and connect
to machine quick disconnect located on
machine. Push and twist to lock cables
together. Plug power cord into outlet.
WARNING
Spray System Preparation
Fill bottle cartridge with suggested cleaning
solution.
Prime pump system by moving valve lever to
the vertical position and depress spray switch
for 30 seconds.
By adjusting valve lever you can vary spray
pressure. The further you move the lever
counterclockwise upwards, the higher the
water pressure. A horizontal position means
maximum water output at maximum pressure.
To turn the machine on, press the power
button on the end of the left handle.
9
1
2
3
4
