10
OPERATION
pressure. The further you move the lever counterclockwise
upwards, the higher the water pressure. A horizontal
position means maximum water output at maximum
pressure.
To turn the machine on, press the power button on the end
of the left handle.
Spray Jets
Adjust the spray jets on the machine base to the desired
position. For most floor cleaning applications adjust the
spray jets so that they spray about 6 inches (15 cm) in front
of the base.
Adjusting Height
Set the handle position to the desired height by pulling and
releasing the black knob with the left hand.
While holding the black knob out, raise or lower the handle
frame with your right hand.
To fix the handle frame into place, release the black knob so
that it locks firmly into one of the holes provided.
Position “0” is off and position “I” is on.
CAUTION
Make sure a suitable pad or brush is mounted before
starting the machine. The immediate contact of the floor and
driver plate without a pad can lead to serious damage of
the floor and/or the machine.
Process of Cleaning
For effective floor cleaning, move the machine forward and
backwards. It is recommended to wet the floor as you move
the machine forward, releasing the solution button when
you move the machine backwards.
To increase the pressure and cleaning effect on certain floor
types like tile and grout, you can lift the machine frame up,
raising the wheels off the ground. When lifting the wheels
off the ground the full weight of the machine lies on the
machine base.
Summary of Contents for SPRAYBORG
