11
OPERATION
CAUTION
Make sure the surface to be cleaned is not damaged by the
increase in pressure.
Omit this measure on very sensitive floors.
End of the Application
Turn off the machine by putting the on/off switch to “O”. If
a cleaning solution was used, fill bottle cartridge with water
and spray out system for 30 seconds.
Make sure to not let solution come in contact with the motor.
Storage
To avoid damage to the handle frame, DO NOT lay the
machine frame on the floor as done with other traditional
cleaning equipment. Remove the pad from the driver plate
by pulling it down firmly. Put the machine frame in an
upright position by pulling the black knob with the left hand
and move the handle frame upwards with the right hand.
The black knob should lock firmly in the top hole.
CAUTION
To allow an easy transportation of the machine, remove the
weight kit if used.
To easily roll the machine, push your foot on the back wheel
axle to create leverage and pull the handle towards your
body. The machine can be moved similar to a dolly now.
Always store with the base in the upright position.
Lifting and Carrying
If you do not have a ramp, we recommend two people to
life machine in and out of a vehicle. Put the firmly locked
handle into a lowered position. Make sure that the machine
base rests on a pad, so that the grip surface of the driver
plate does not get damaged or hooked onto a carpeted
surface.
Grip the machine from each side as shown.
When lifting the machine in or out of the vehicle, set the
Summary of Contents for SPRAYBORG
