30
■
How to adjust the height of the steering wheel and the seat position:
The steering wheel can be adjusted to 3 levels, and the seat can be adjusted to slide back and
forth.
Please adjust the U-nuts and bolts which
secure the handle shaft.
Grab the seat
slide lever, then
adjust the seat
for the suitable
position.
Oil Parts Inspection, Replacement, and Lubrication:
Please refer to the hour meter display on the meter panel to determine the proper time
to check the oil parts, replace, or lubricate as recommended.
When this machine is shipped, it is lubricated with oil; however, before operating the
machine, make sure that it is lubricated with the described oil, in the described parts,
and in the described quantities.
-To always operate this machine in good condition, perform oil changes as
recommended.
- When performing inspection, replacement, or lubrication of oiled parts, place the
machine on a flat, open surface. Switch on the engine and warm it up to confirm it is
working properly. Then switch off the engine, allow it to cool down and remove the
spark plug cord.
After switching off, please wait at least 5 minutes for all parts to cool down sufficiently
before touching the machine. Immediately after the engine has stopped, the body will
be very hot and can cause burns if touched.
After switching off the engine, oil will still be in the engine and transmission so the
quantity of oil remaining will not be exactly displayed.
For safety reasons, remove the key when not working.
**After changing oil, please dispose of waste oil appropriately. **
Transmission oil inspection, lubrication, and replacement
Inspection
Remove the oil inlet plug from the rear part of the transmission case on the transmission, and
check the oil.
Replacement
Prepare a suitable container for discarded oil. Replace oil after the
first 20 hours
of operation
and roughly
every 100 hours
thereafter by removing the drain plug from the bottom right side of
the transmission.
Bolt
U-nut
Seat Slide Lever
