Only use original genuine OREC parts. Other parts may be dangerous for your health and for
the bystanders and the machine. If some flails are missing important vibrations will occur. If
you feel such vibrations on the handlebar, check the rotor and the flails. Vibrations may cause
loosening of the bolt and nuts and may crack the steel of the machine.
TIGHTENING OF BOLT AND NUTS
Check for tightening of bolt and nuts according to the chart. Vibrations of the
machine may loosen bolt and nuts.
LUBRICATION :
Grease the front wheel axle(1 Figure 15) with grease NLGI N°2.
Grease the differents points G(Figures 16 & 17) with light oil.
W
IRES GAP
:
Transmission wires :
If the machine does not stops when the drive clutch lever is released, adjust the tension wire as
follow : unscrew the locking screw (A Figure 18) and unscrew the nut B. Try to move the machine
again. Perform the adjustment again if needed. When the adjustment is performed screw the locknut
A on the nut B.
If the machine doesn’t move when driving clutch lever is pressed, adjust the tension wire as follow :
unscrew the locking screw (C Figure 18) and unscrew the nut D. Try to move the machine again.
Perform the adjustment again if needed. When the adjustment is performed screw the locknut C on
the nut D.
Figure 15
Figure 16
Figure 19
Figure 17
C
Figure 18
E
F
A
B