17
Blade wire :
•
If the blade does not stop when the blade lever is released, adjust the tension wire as follow :
unscrew the locking screw (A, Figure 19) and unscrew the nut (B, Figure 19). Try the machine again.
Perform the adjustment again if needed. When the adjustment is performed screw the locking screw
(A, Figure 19) on the nut (B, Figure 19).
•
If the blade does not move when transmission lever is pressed, adjust the tension wire as follow :
unscrew the locking screw (A, Figure 19) and after screw the nut (B, Figure 19). Try the machine
again. Perform the adjustment again if needed. When the adjustment is performed screw the locking
screw (A, Figure 19) on the nut (B, Figure 19).
Blade brake is connected to the blade wire. Check if the blade brake works correctly when
adjusting blade wire control.
Direction wires :
If the wheel is not locked with side clutch lever engaged, adjust as follows:
•
Unscrew locking nut (E, Figures 18,19).
•
Screw or unscrew the nuts (F, Figures 18,19) .
•
Try the machine.
•
Adjust again if it is necessary.
•
Screw the locking nut “E” on the adjusting nuts “F”.
Handlebar Control wire adjustment
If the handlebar control doesn’t work correctly, adjust as follow :
- If it is difficult to free the handlebar, unscrew the nut (A, Figure 20,21), then screw the nut B to
increase the wire tension. When the adjustment has been performed, screw the nut A again.
- If the handlebar doesn’t lock properly, unscrew the nut (A, Figure 20,21), then unscrew the nut A to
decrease the wire tension. When the adjustment has been performed, screw the nut B again.
A
A
B
B
Figure 20
Figure 21
