9
CONTROLS
DRIVING CLUTCH LEVER
Push the lever (1, Figure 1) down to the
handlebar to make the machine move. Release
the lever, then the machine stops.
BLADE CLUTCH LEVER
Blade clutch lever makes the engine drive the
blade to mow. Push the lever (2, Figure 1) then
pull up the lever (3, Figure 1) to make the blade
spin.
Release the lever, then the rotor stops.
WARNING
Never try to start or stop the engine with
blade engaged.
SPEED LEVER
This lever (4, Figure 1) allows to select 3 forward speeds (1, 2, 3), 1 reverse speed (R) or 1 neutral
position(N).
WARNING
Be sure to change speed only when driving clutch is disengaged and machine is stopped.
THROTTLE LEVER
Push the throttle lever (5, Figure 1) to left to increase engine speed, push the throttle lever to right to
decrease engine speed to idle rpm. Always operate mower at full engine speed.
SIDE CLUTCH LEVERS
The side clutch levers (6, Figure 1) are used to change the direction of the machine. Grip right lever to
turn right and left lever to turn left. To move the machine when engine is cut off, grip the both levers.
DANGER
Do not grip two levers on slopes when engine is running.
HANDLEBAR ADJUSTMENT LEVERS
Grip the lever (7, Figure1) to move handlebar right and
left. And grip the lever (8, Figure 1) to move handlebar
up/down.
CHOKE LEVER
(1,
F
IGURE
2)
Push this lever to X to operate the choke to start engine
cold, when engine has start release it to Y.
IMPORTANT
There is no need to choke when the engine is hot.
Figure 1
1
3
4
2
6
8
6
Y
X
1
7
5
2
Figure 2
X
Y
1
2
