OREC RM60W
16
5) Adjust the height of cut lever as needed.
6) Start mowing.
7) Take reverse procedure to stop mowing.
8) Stop the engine.
WARNING
1) Regularly clean the grass around the engine and muffler, because it may cause fire or overheat. It is also
good to clearn inside of engine bonnet.
2) It is possible to get damaged by thrown object such as stone, wire, can and so on. Pay attention to remove
them before mowing. Also keep neighbors away from the machine.
3) Mud and dust near the cooling system may raise oil temperature in the engine and in the HST unit. Regularly
clearn the mud and dust away.
4) Do not mow toward building, river, cliff and person for the purpose to avoid fall or collision accident.
5) When mowing on slope, do not stand up in the mountain side, because there is risk of slliping down into the
mowing deck. It may lead to serious injury.
6) In case of removing grass or wire from the blade, make sure to stop engine first and check if blade is
completely stopped.
7) Before to start mowing, make sure that defective part in previous work is already repaired.
8) For your safety, inspect blade and blade disc rotary.
9) In case of hitting obstacle during mowing, stop the engine and repair if necessary. If mowing is started without
proper repair, it may lead to accident.
10) There is risk of slipping when grass is wet or it is rainy day. And grass may be stuck inside the mowing deck,
leaving the engine overworked. In such case, stop the work and wait until grass get dry.
11) Do not kick the grass into mowing deck because blade is rotating inside of blade cover. Do not use hand or
foot to let grass into mowing deck.
12) This machine is specially designed to cut grass around the tree. Do not use it in a field with stone or uneven
field to avoid thrown object. Check the field condition prior to the mowing work.
CAUTION
1) Wear protective cloth, boots, hat/helmet, protective grasses and gloves.
2) Check the field in advance, and remove stone, stamp, wire or cans away.
3) Use a bridge against the gap of more than 70mm. Crossing the gap in high speed may lead to tipping over or
machine damage. Cross the gap only in low speed.
4) In case front wheel stuck into the hole or ditch, do not try to turn the steering wheel. Stop the engine and
move up the machine to get away.
5) Pay attention to avoid accident to be pinched between tree and machine.
6) Pay attention to the blade that is rotating in high speed.
7) Pay attention to activate the blade clutch lever slowly.
8) Do not start mowing in lowest cutting height, because it may cause quick wear of blade belt.
9) When mowing is finished, move the blade clutch elver to OFF position, wait 2-3 seconds then move the height
of cut lever to transport position. This is to avoid thrown object before blade stops.
10) In case of too much grass to cut or in case engine frequestly stops, slow down the speed or mow twice in
high and low popsition.
TIP :
1) When this machine is used for the first time, use it in a field without stone, and mow straight slightly overlapped.
2) In case of work on slope, it is recommended that RH of machine looks toward the hillside so that engine plug
is heading up. Otherwise, engine oil may be burned and white smoke may appear.
3) In case height of cut lever is moved back to tranport position, blade clutch lever also returns back. However,
this way of use is not recommended because it may damage the lifetime of blade belt.
4) Blade clutch cannot be activated when heigh of cut lever is in transport position.
5) Basically use speed lever to stop the machine. In case of emergency situation, machine stops when parking
brake pedal is pressed. At same time, speed lever goes back to N position.
6) Remember to remove key and keep it when operator leave the machine.
