EN
6
SENSOR DATA TRANSMISSION
The sensor reception icon in the remote sensor area
shows the status.
To search for a sensor:
Simultaneously, press and hold
MEM
and
CHANNEL
for 2 seconds.
NOTE
If the sensor is still not found, check the batteries,
obstructions, and remote unit location.
ICON
DESCRIPTION
and "- - . -"
(Outdoor
temperature area)
The sensor cannot be found.
Search for the sensor or check
batteries
A channel has been found
and sensor signal is being
received
Main unit is searching
for the sensor(s)
CLOCK
CLOCK RECEPTION
This product is designed to synchronize its date and time
automatically once it is within range of:
•
DCF-77 generated from Frankfurt, Germany for Central
Europe.
•
MSF-60 generated from Rugby, England.
NOTE
Slide the
EU / UK
switch to appropriate position for
your location. Repeat each time you
reset the unit.
NOTE
Initial reception takes 2-10 minutes for first set up
or when
RESET
is pressed. Once complete, the reception
icon will stop blinking. If the signal is weak, it can take up
to 24 hours to get a valid signal.
RECEPTION SIGNAL
Clock signal reception indicator:
To enable and force a signal search:
Press and hold for 2 seconds.
To disable the signal reception:
Press and hold for 2 seconds.
STRONG SIGNAL
WEAK SIGNAL
NO SIGNAL
SET CLOCK
If the clock signal reception is enabled and a signal is being
received the clock does not need to be manually set.
1. Press and hold
MODE
for 2 seconds.
2. Press or to change the settings.
The clock collects the radio signals whenever it is within
1500 km (932 miles) of a signal.
BAR686_M_EU_EN_RUN_R2
2006.6.21, 11:15 AM
6
