5
EN
UNIT
LOCATION
Main
Indoor Temperature Area
Remote
Outdoor Temperature Area
TABLE STAND OR WALL MOUNT
The table stand is in the back of the product. See below
for how to assemble the table stand.
CHANGE SETTINGS
CHANGE SETTINGS
REMOTE SENSORS
This product is shipped with 2 sensors: THR268 and
THN122N Thermometer Sensors that collect
temperature data. Data can be collected from up to 3
sensors. Additional sensors sold separately.
SET UP SENSOR - THR268
1. Assign a different channel to each remote sensor
by changing the channel switch in the battery
compartment of the remote sensor.
2. Select the units of measurement for the temperature
display on the
°
C/
°
F slide switch.
1. Press and hold
MODE
for 2 seconds to enter setting
mode.
2. Press
or
to change settings.
3. Press
MODE
to confirm.
To mount the product on a wall, put the stand inside
the back of the unit and then place it on a wall, as shown
below.
3
4
2
1
1
4
2
3
3. Install the batteries strictly according to the polarities
shown.
P/N: 086L003873-076 REV1
6/47
