GB
6
Table-stand
First, unlock the two panels by pressing the unlock button. Lay the
control panel on a flat surface. Then adjust the angle of the display
panel for best display and support.
HOW TO RESET THE UNIT
The
RESET
button allows you to return all settings to its factory
values. The button is required only when the unit is not operating
in a favorable way, such as in the rare case of a malfunction.
The
RESET
button is located at the back of the unit below the
battery compartment. Press the button with a blunt stylus to reset
all values to their default settings.
MAINTENANCE
When handled properly, this unit is engineered to give you years
of satisfactory service. Here are a few product care instructions:
1. Do not immerse the unit in water. If the unit comes in contact
with water, dry it immediately with a soft lint-free cloth.
2. Do not clean the unit with abrasive or corrosive
materials.Abrasive cleaning agents may scratch the plastic
parts and corrode the electronic circuit.
3. Do not subject the unit to excessive: force, shock, dust,
temperature, or humidity. Such treatment may result in
malfunction, a shorter electronic life span, damaged batteries,
or distorted parts.
4. Do not tamper with the unit’s internal components. Doing so
will terminate the unit’s warranty and may cause damage. The
unit contains no user-serviceable parts.
5. Only use new batteries as specified in this instruction manual.
Do not mix new and old batteries as the old batteries may leak.
6. Read this instruction manual thoroughly before operating the
unit.
SPECIFICATIONS
• Temperature Measurement
Main unit
Indoor Temperature measurement
Proposed operating range
: -5.0
°
C to +50.0
°
C
(23.0
°
F to 122.0
°
F)
Temperature resolution
: 0.1
°
C (0.2
°
F)
New Moon
Waxing Crescent
First Quarter
Waxing Gibbous
Waning Crescent
Last Quarter
Waning Gibbous
Full Moon
HOW TO USE AND SCAN
THE MOON PHASE
BAR938HG is equipped with a moon phase display and scanner with
which eight moon phases are displayed on the screen from new
moon to waning crescent. The one falls on the current day will flash
on the screen.
If it is a full moon or new moon day, the icon will flash faster.
The eight phases are:
To check the moon phase for a particular day, press the
UP
or
DOWN
button once. The clock will enter moon phase scanning
mode.
Use the
UP
or
DOWN
button to locate the date you want to check.
The calendar will be day-driven in this mode.
You can go back in time or travel to the future, any day between the
years 1990 to 2089. The corresponding moon phase will appear
immediately on the screen.
The unit will return to the last display mode when the
UP
and
DOWN
buttons are left idle for 10 to 15 seconds.
HOW TO WALL MOUNT OR
USE THE TABLE STAND
Wall-mount
First, adjust the control panel and display panel so that they are
parallel to each other. Then press the side of the display panel
slighty towards the side of the control panel. Slide the
LOCK
button to the right to lock the 2 panels together. The unit can be
wall-mounted using its recessed screw holes.
BAR938HG-E R3 OP
8/21/04, 11:25 PM
6
Black
