9
EN
CLOCK AND CALENDAR
This product tracks the time and date for 1 local location, and
1 world city that you choose. The information is shown in the
top left and bottom right areas of the display.
RADIO-CONTROLLED CLOCK
The time and date are automatically updated by radio-
controlled clock signals from official time-keeping
organizations in Frankfurt (Germany) and Rugby (England)
unless you disable this feature. The signals are collected by
the remote sensor (RTGR328N) whenever it is within 1500
km (932 miles) of a signal.
Initial reception takes 2 – 10 minutes, and is initiated when
you first setup the unit, and whenever you press RESET. Once
complete, the reception icon will stop blinking.
An icon indicates the signal strength.
ICON
DESCRIPTION
If no signal is found, check the sensor batteries.
TURN RADIO-CONTROLLED CLOCK ON/OFF
If you wish to manually set the clock, you must first disable
the radio-controlled feature. To do this, navigate to the Clock
/ Alarm Area. Then, press and hold DOWN on the main unit
for 2 seconds. To enable it, navigate to the Clock / Alarm
Area, then press and hold UP for 2 seconds.
The house icon
indicates that the
radio-controlled
clock is ON. No
icon means that
it is OFF.
SET CLOCK
You only need to do this if you have disabled the radio-
controlled clock, or if you are too far from a RF signal.
1.
Press SELECT to
navigate to the Clock
Area.
▲
will show in
the lower left corner
of the Area.
2.
Press and hold MODE
for 2 seconds. The
Clock and World
City Areas will blink.
3.
Press UP or DOWN to choose the city you are
LOCATED IN. Press and hold for rapid search.
Signal in
progress
No Signal
OR
OR
