GB
4
MEASURE WEIGHT AND BODY MASS INDEX
(BMI)
If you do not wish to calculate your BMI, simply
step on the scale and wait a few moments until
your weight displays.
1.
Press
on the remote unit to
switch to the user profiles.
2.
Press
or
until the desired user
number displays. If you select “GUEST”,
you will need to enter your height
( 3, Steps 2 - 5).
3.
Step on the scale. “- - - -” will flash on
the display, followed by your weight. The
scale will beep when the measurement
is complete, and the weight will show on
the remote unit.
4.
To save the measurement to memory, press
and hold
for 2 seconds on the
remote unit. A “1” will appear in the memory
box on the remote display once the record
has been stored. (Each new measurement
is assigned to the first record number (1).
All other records are pushed back one
digit -- e.g., 2 becomes 3, and so on). The
weight will be shown first, followed by the
BMI value if the height has been set for that
user record. If no height has been set,
“- - - -” will show for the BMI value.
The scale display will automatically
go off after 5 - 10 seconds, even if weight is
still applied. The remote display will return
to clock mode if it is left idle for 30 seconds.
Press any key to prolong the display.
ACCESS USER MEMORY
This product can save up to 7 records for each
user. Each record is saved with the time-date
stamp, weight, and body mass index (BMI)
calculation. Records cannot be saved for
guests.
1.
Press
to switch to the user
profiles.
2.
Press
or
until the desired user
number appears.
3.
Press
. A “1” will show in the MEM
box for the selected user.
4.
Press
or
to scroll through the
records. Weight and BMI value will
alternatively display every 2 seconds.
The time and date for the measurement
are shown at the bottom of the screen.
NOTE
If the height has not been set,
"- - - -" will display for the BMI value.
Refer to the SET USER PROFILE section
( 3) for height setting instructions.
RESET SYSTEM
The RESET buttons are located in or near the
battery compartments for the scale and remote
unit. Press these buttons with the tip of a blunt
object (such as a ballpoint pen) whenever you
change the batteries, or whenever performance
is not behaving as expected (e.g., unable to
establish radio frequency link with remote unit).
This will return all settings to default value.
Once you press RESET, repeat Steps 6 - 7 of
the GETTING STARTED section ( 3).
RESET does not erase user
profiles, records, or measurement units
that were previously stored. To erase a
record, simply record new data over it.
BATTERIES
Batteries for the remote unit and scale are
supplied with this product. Replace them
whenever the low battery signal ( , , or )
displays on the scale or remote unit. Remove the
battery compartment lid on the bottom of the
scale or back of the remote unit, and insert the
batteries. Be sure to match the correct polarity,
as shown in the battery compartment. Before you
close the lid, press the RESET button with the
point of a blunt object (such as a ball point pen).
Repeat Steps 6 - 7 of the GETTING STARTED
section ( 3) to set up the remote unit to
display scale information.
Insert the batteries in the remote
unit before the scale. Do not use
rechargeable batteries. Batteries can be
harmful to the environment. Contact your
local waste disposal authority for proper
disposal instructions.
NOTE
NOTE
NOTE
BWR 102 new English r8 op
12/27/03, 10:25 AM
4
Black
