EN
EN
MEMORY MODE
The GR101 can automatically store up
to 30 previous measurements. To display
previous measurements taken by a user
with a profile:
1. Press the User Switch (1 to 4)
corresponding to your User Profile.
2.
Press / to cycle
through your previous
measurements. The
MEM box will indicate
the current memorized
measurements that
you are viewing.
3. Step onto the Scale. Stand still while
the measurement is being taken.
The Scale’s green LCD Indicator will
blink.
NOTE
It is recommended that you
step onto the scale
with your bare
feet. The electric signal sent from the
scale cannot give readings if socks
or shoes are worn. As a result, only
weight and BMI will be measured.
4. Your weight and BMI will first appear
on the Remote Monitor. Remain still,
and the green LED Indicator will blink
more rapidly to record your Body Fat
and Body Water measurements.
5
NOTE
If is shown on the Remote
Monitor, the maximum loading
capacity for
the Scale has been
exceeded. Step off the Scale and try
again with less than 150kg of weight.
NOTE
If you wait for too long
before stepping on the Scale, your
measurements will not be taken
correctly. Step off the Scale and
follow these instructions again.
5. Once the green LED stops blinking,
your Body Fat and Body Water
measurements will be alternately
displayed on the Remote Monitor.
Weight, Body Fat and BMI Display:
Body Water Weight and Percentage
Display:
GR101_E_V0.INDD
2005.8.15, 9:29 AM
5
All manuals and user guides at all-guides.com
all-guides.com
