8
EN
GETTING STARTED
BATTERIES
Batteries for the remote and main units are supplied
with this product. Replace them whenever the low
battery signal (
) displays. Remove the battery lid
on the bottom of the main unit. Use a small Phillips
screwdriver to remove the remote unit compartment
lid. Be sure to match the correct polarity, as shown
in the battery compartment. After you change the
batteries, press the RESET button with the point of a
blunt object (such as a ball point pen).
Insert the batteries in the remote unit before
you set up the main unit. Do not use rechargeable
batteries.
CHANGE SETTINGS
Press and hold CLOCK or ALARM for 2 seconds to
enter setting mode. Then, press UP or DOWN
to change each setting. Press and hold to enter fast-
setting mode. Press CLOCK or ALARM to switch
between settings.
NOTE
