V) Quick Start
Battery Installation
1. Open the battery cover at the end of the unit.
2. Insert 1 x AAA alkaline battery with the polarity in the
direction as shown.
3. Replace the cover.
Note:
a) Battery installation should be done under adult supervision.
b) Remove the battery if
MyPix
is not going to be used for
some time. This will save battery life.
c) Non-rechargeable battery is not to be recharged.
d) Rechargeable battery is to be removed from the
MyPix
before being charged.
e) Rechargeable battery is only to be charged under adult
supervision.
f) Exhausted battery is to be removed from the
MyPix.
g) The supply terminals are not to be short-circuited.
Power On/Off
Power On
Press the Power button. The LCD will light up.
Power Off
Press the Power button. The LCD will turn off.
Power Save
If no button has been pressed for 30 seconds, the LCD will switch off.
Press any button to reactivate
MyPix
.
6. Power ON/OFF button
7. USB port with rubberized covering
8. 4 interchangeable inlays
9. Battery cover
10. Cover release button
11. Reset hole
12. Necklace loop
13. Belt clip mount
14. Belt clip
15. Necklace
3
4
PA18_manual_2_Sept.1 9/5/05 16:36 Page 4
