17
GB
Recall LAP Memory for TIMER 1
1. Press SELECT in TIMER 1 mode after it is reset to 00:00:00 to
enter the LAP memory recall mode (recall can only be activated
when timer is not working).
2. Press +/- to toggle between memory groups. In the first display,
the date and time stamp will be shown for the starting time for
that corresponding memory group.
3. Press FUNC to recall the corresponding total (TTL) time.
4. Press +/- to scroll among the LAP memory
5. Press FUNC to go back to TIMER 1.
Refer to Fig. 5c to recall the LAP memory for TIMER 1.
Note:
• If left idle for 30 sec, it will go back to TIMER 1.
Delete the LAP Memory for TIMER 1
The LAP memory group(s) can be deleted. It can either delete one
particular LAP memory group or delete all LAP memory groups.
Delete one LAP memory group
1. Press SELECT in TIMER 1 mode after it is reset to 00:00:00 to
enter the LAP memory recall mode.
2. Press +/- to select the particular memory group to be deleted.
3. Press and hold FUNC for 2 seconds in that particular group to
enter the LAP memory delete mode.
4. Press and hold FUNC for 2 seconds to confirm deletion of the
particular memory group. “donE” will be shown on the display
after the deletion.
5. Press FUNC twice to quit to TIMER 1.
Notes:
a) If left idle for 30 sec, it will go back to TIMER 1.
b) To cancel the deletion of the LAP memory group, press FUNC
to go back to the LAP memory recall mode.
c) If no memory group records exists, “--” will be shown on the display.
Refer to Fig. 5d to delete one LAP memory group for TIMER 1.
Date & time stamp
Memory group's total time
Lap time for
memory group
Fig.5c
SELECT
FUNC
FUNC
+ / -
+
-
-
Fig. 5c
Fig.5d
Fig.5e
SELECT
2 sec
SET
SET
2 Sec
FUNC
SET
Fig. 5d
Fig. 5e
