9
EN
CHANGE INDIVIDUAL CLOCK OR USER
PROFILE SETTINGS
If after the initial setting of the clock / user profile (as
detailed in previous section), you wish to change the clock
time or edit one of the user profile settings, simply:
1. Press
MODE
to navigate to Clock or User Profile
Mode.
2. Profile Mode only; use / to scroll to the setting
you wish to change.
3. Press and hold
SET
to enter setting mode.
4. Press / to change a value and
SET
to confirm.
ALARM
When in the Clock Mode, press to toggle between the
Clock and Alarm Mode.
To set the alarm:
1. Press
MODE
to navigate to Clock Mode.
2. Press to switch
to Alarm Mode.
3. Press and hold
SET
to enter the setting mode.
4. Press / to change a value and
SET
to confirm
and move on to the next setting.
5. The setting sequence is:
•
Hour
•
Minute
•
On / Off
To stop the alarm sound, press any key
PULSE METER / STRESS INDEX (AVAILABLE
IN PE826 ONLY)
For first-time use, or after replacing a battery or
resetting the unit, user must calibrate stress index
baseline, otherwise no valid reading can be obtained.
To calibrate your stress index baseline:
The index is highly individual, so you need to calibrate
your personal baseline before you use this function to
monitor your stress status.
Make sure you relax for 2 to 3 minutes before you start
the calibration:
1. Press
to enter Pulse Mode.
2. Press to enter
calibration setting.
3. Press and hold
SET
to start calibration.
PE82X_M_EN_N_R0.p65
2008.2.19, 1:09 PM
9
P/N: 086L003991-079 REV1
Page 10 of 126
