Oregon Scientific RA313P, User Manual

NE

5

HOW TO SET THE ALARMS

To set an alarm:

1.  Press 

    once to enter alarm mode. The  

     last selected

 displayed. If  you        

     have never set 

     as 0:00.

2.  Press

for three seconds. The hour  

     digits will blink.

3.  Enter the hour using [   ] and [   ].
4.  Press               . The minute digits will blink.
5.  Enter the minutes using [   ] and [   ].

6.  Press

to exit. The alarm-on icon will   

     be displayed

arm is activated.

    You can activate / disactivate the alarm by pressing the

   [   ON / OFF ]

 button.

When  the  alarm  sounds,  the  display  will  light  up  for  8-

seconds with the alarm icon flashing.
The  four-step  crescendo  function  allows  the  alarm  to  start 

off  gently  and  step  up  its  intensity  for  four  times.  Without 

interruption, the alarm will go off for a total of two minutes.

To stop the alarm, you can use either of the three buttons:

[ 

] , 

  or [ 

ON / OFF 

] .

• Pressing [                        ] during an alarm will invoke the 
    snooze function,  

arm and let it sound 

   again after eight 

• Pressing 

 or [

ON / OFF 

] will stop    

    the alarm,

 it will go off at the set time the following day.

•  If [  

 ON / OFF

 ] again, the alarm will be deactivated    

     all together.

HOW TO RESET THE UNIT

There is a 

RESET

 function near to the battery compartment. 

It allows you to return all settings to its factory values.

To use the RESET:

1.  Locate the 

RESET

 beside the door tab.

2.  Use a blunt stylus to press the [

 RESET

 ] once.

PRECAUTIONS

This  unit  is  engineered  to  give  you  years  of  satisfactory 

service if you handle it carefully. Here are a few precautions:
1.  Do not immerse the unit in water. If you spill liquid over    

     it, dry it immediately with a soft, lint-free cloth.
2.  Do not clean the unit with abrasive or corrosive materials. 

      They may scratch the plastic parts and corrode the  

     electronic circuit.
3.   Do not subject the unit to excessive force, shock, dust,   

      temperature or humidity, which may result in malfunction,       

      shorter electronic life span,damaged battery and distorted   

      parts.
4.  Do not tamper with the unitís internal components. Doing    

      so will invalidate the warranty on the unit and may cause   

       unnecessary damage.The unit contains no user-serviceable   

       parts.
5.  Only use fresh batteries as specified in the userís instructions.  

       Do not mix new and old batteries as the old ones may leak.
6.   Always read the userís instructions thoroughly before    

      operating the unit.

313p en.indd   5

2006.9.26   3:00:10 PM

 time of the alarm will be

the alarm before, the time will be   displayed   

 indicating the al

which will stop the al

minutes.