4
GB
- Unit has received radio signal.
- Clock is searching for radio signal but not yet
received. It is recommended that you reposition or
rotate the antenna.
- The display time has been manually set and is not
synchronized to the RF signal.
- When the antenna symbol blinks, a reception is going
on. A full reception takes approx. 2 to 10 minutes,
depending on the quality of the signal received.
The hourly scanning may take a few seconds only.
To install the adapter:
1. Insert adapter into jack at the bottom of the unit.
2. Plug the adapter into the adapter socket.
Note: Making sure the voltage is correct, plug the other end
of the power adapter into a free wall socket.
Once the power adapter is in place, you can select to turn on the
projector for longer periods of time (such as throughout the night)
by sliding out the PROJECTION LIGHT ON - switch on the back
of the unit. To turn off the projector, slide the switch back.
Note that this switch can only be used with the power
adapter installed. For momentary projection, use the
[
].
HOW TO USE THE BACKLIGHT
Press [
] once. The back light will activate
for five seconds. The projection will also be on for five seconds.
ABOUT RADIO RECEPTION
The RM328PA is a radio frequency (RF) controlled clock. The
clock time will automatically synchronize with WWVB-60 time-
signal transmission from the US when put within range. The benefit
of a RF controlled clock is that highly-accurate time is maintained
and manual adjustments to the time and date are not be required.
When the batteries are first installed, the RM328PA will
automatically search for a radio signal.
When in search mode, the antenna icon [
] will blink. This
process takes between two (2) and ten (10) minutes. After initial
search, short periodic reception-signal scans will commence several
times a day.
The antenna icon indicates the quality of reception.
