5
GB
- Unit has received radio signal.
- Clock is searching for radio signal but not yet
received. It is recommended that you reposition or
rotate the antenna.
- The display time has been manually set and is not
synchronized to the RF signal.
- Radio reception is disabled and no signal reception
will be initiated until it is enabled again.
- When the antenna symbol blinks, a reception is going
on. A full reception takes approx. 2 to 10 minutes,
depending on the quality of the signal received.
The scanning may take a few seconds only.
No indicator
the last full hour will be indicated.
For better reception, place the clock away from metal objects
and electrical appliances to minimize interference.
If you wish to disable the auto-reception feature, press the
[
] BUTTON for
3
seconds. The RADIO RECEPTION
SIGNAL will disappear. The unit will not respond to radio
signals.
To enable the feature again, press the [
] BUTTON for
3
seconds. The RADIO RECEPTION SIGNAL will start
blinking to initiate reception automatically.
HOW TO SET THE CLOCK
MANUALLY
To set the clock, hold [MODE/SET] for
3
seconds. The
display will return to MODE 1, with the hour digits blinking.
Use [
] or [
] to select the hour. Keep pressing the
button will increase or decrease the value rapidly.
Press [MODE/SET] to confirm. The minute digits will
blink. Repeat the same procedure to set the minutes, then
day, month, display language, day-of-week and offset
for the second time zone.
Note that the time and date are displayed in 24-hour
clock and DAY-MONTH format, respectively. For
display language, you can choose among English,
French, German and Italian--in that order. Day-of-week
is the usual sequence of Monday through Sunday.
For the second time zone, which is indicated by the
ZONE ICON, enter the hour offset and the
RM338SP
will
calculate the second time accordingly.
If there is an item you do not wish to change, simply press
[MODE/SET] to bypass the item.
When you are done, press [MODE/SET] to exit. The
display will return to the mode last chosen.
