6
GB
HOW TO USE THE NIGHTLIGHT
RM813PA is equipped with a nightlight. To turn on the nightlight
temporarily for testing its functionality, press the [TEST] button
with a blunt stylus at the bottom of the unit. The light will be on
as long as the button is pressed and held.
For continuous use of the nightlight, AC Power adapter is required
to be connected. For instructions on how to install the adapter,
please see Section “Continuous Projection feature with Power
Adaptor.”
Once the power adapter is in place, slide the [LIGHT ON
] switch
(located at the side of the unit) to the back i.e. the “On” position.
The nightlight will be turned on for a longer time. To turn the light
off, simply slide the switch in the opposite direction.
Note that this switch can only be used when the power adapter is
installed. For turning the light on momentarily, use the [TEST]
instead.
HOW TO CHANGE
THE GUIDING LIGHT BULB
RM813PA is pre-installed with a 3V lightbulb. In case you want to
change the lightbulb follow the instructions below:
1. Un-install the power adapter from the unit to prevent electric
shock. Also, remove the batteries from the battery compartment.
2. Remove the tail of the unit as shown.
3. Then, remove the lightbulb by rotating it in a anti-clockwise
direction.
4. Replace with new light bulb with correct specifications. Make
sure the light bulb is securely fixed.
5. Replace the tail of the unit as shown.
6. To test if the guiding light is working properly, install batteries
into the battery compartment and press the [TEST] button. The
light should be turned on as long as the button is held.
7. If the light does not turn on, check if the lightbulb is broken or
if the lightbulb is well-connected to the unit.
MAINTENANCE
When handled properly, this unit is engineered to give you years
of satisfactory service. Here are a few product care instructions:
