EN
8
Even though there are areas that may have more
difficulty in receiving a signal, the
atomic
clock contains
accurate quartz movement and will retain precise timing
if the signal is missed on a rare occasion.
Reception can be affected by a number of
factors. For best reception, place the device away from
metal objects and electrical appliances. Other causes
for signal interference include electrical transmission
tower, steel reinforced construction, and metal siding.
Reception is ideal when placed near a window.
NOTE
TURN ATOMIC CLOCK ON / OFF
To manually enable the reception of the
atomic clock
:
Press and hold the
UP
button for 2 seconds until the
atomic clock
reception symbol appears and flashes.
To manually disable the reception of the RF signal:
Press and hold the
DOWN
button for 2 seconds until
the
atomic clock reception
symbol disappears.
SETTING THE CLOCK MANUALLY
To adjust the clock settings manually without automatic
atomic
clock synchronization, remember to disable the
atomic clock reception
first.
To set the clock manually therefore:
1. Press and hold the
DOWN
button for 2 seconds
until the
atomic clock reception signal
disappears.
2. Press and hold the
CLOCK
button to enter the clock-
setting mode. Then use the
UP
or
DOWN
button to
adjust the value of each setting.
CLOCK MODE
The Clock mode has 3 types of display:
a) HH_MM_SS / Calendar
b) HH_MM_Day-of-the-Week / Calendar
c) HH-MM-ZONE OFFSET / Calendar
Press the
CLOCK
button to toggle between the
three modes.
CLOCK SETTING MODE
To set the time:
1. Press and hold the
CLOCK
button for more than
2 seconds.
2. Press the
CLOCK
button two more times. (Use the
UP
and
DOWN
buttons to adjust the hour).
NOTE
RM818PA English R1
9/1/04, 11:20 AM
8
