5
GB
HOW TO ENABLE OR DISABLE
AUTO-RECEPTION
To disable the automatic signal reception feature, hold down
[ZONE] for 2 seconds. The [
] will disappear and the RRM-
112A will not receive signal from the US Atomic Clock.
Note: The radio needs to be off before disengaging the signal
reception feature.
To activate the signal reception feature again, hold down the
[ ] button for two seconds.The [
] signal
will start blinking to initiate reception automatically.
When the automatic reception feature is active, manual settings
will be over-ridden by next signal recepttion.
AND SELECT DAY-OF-THE-WEEK
DISPLAY LANGUAGE
the automatic signal reception feaure is disengaged, the RRM-
112A can be manually set and will operate as quartz clock. To
manually set the RRM-112, the clock needs to be in normal time
display mode.
1. Press [CLOCK] for two seconds and the hours digits will start
flashing.
2. Enter the hours using the VOLUME [ + ] and VOLUME [ - ]
buttons. Hold down either button to rapidly increase or decrease
the value.
3. Press [CLOCK]. Minutes digits will flash.
4. Enter the minutes using the VOLUME [ + ] and VOLUME [ - ]
button.
5. Press [CLOCK].
6. Follow the same procedure to set the year, month, day and the
display language (English, French and Spanish).
Press [CLOCK] to save the changes and exit. If changes are made
after the minute adjustment, the seconds will reset and start from
zero.
The unit will also save all changes and return to normal display
automatically after the unit has been left idle for 1 minute.
HOW TO SET THE ALARM
1. Select between Beep-Alarm-On, Radio-Alarm-On and Alarm-
Off mode by pressing the [ ON / OFF ] button.
2. Press and hold [ ON / OFF ]for two seconds. Hours digits
will flash.
3. Use VOLUME [
+
] / [
-
] to enter the hours.
4. Press [ ON / OFF ]. Minutes digits will flash.
5. Use VOLUME [
+
] / [
-
] to enter the minutes.
6. Press [ ON / OFF].
7. If the Radio Alarm-On mode has been selected, press [AM / FM]
to select the correct frequency and then [STATION] to select the
radio station.
8. Press [ ON / OFF ].
9. Use VOLUME [
+
] / [
-
] to set the volume. Of the wake up radio.
10. Press [ ON / OFF ] to exit.
11. In Beep Alarm-On mode, a 2-minute crescendo alarm will sound
when alarm is active. In Radio Alarm-On mode, the radio will
remain on for 2-hours before turning off automatically if not
manually deactivate.
