EN
3
1
6
8
9
2
3
5
4
7
LCD
1. Shows when in Target Mode
2. Shows when in Timer Mode and flashes when you
are in another display and timer is running
3. Shows when keypad lock is enabled
4. Shows when alarm is activated
5. Shows when in Timer Mode
6. Shows value of step, distance and calorie, clock /
alarm time, timer and user profile
7. Shows when in 7-day Memory Mode
8. Colored bar shows the memory weekday and target
status
9. Dot matrix shows various icons to indicate the mode
/ display you are in
GETTING STARTED
SET UP
You must set up the device (as shown below) when you
first activate the unit, reset it or change the batteries, or
your pedometer will not work properly.
1. To activate the device, pull out the insulation tape
underneath the battery cover.
2. Set the clock and user profile (see Clock / User Profile
section).
3. Attach the pedometer to your belt or training attire at
waist level. Secure it at horizontal position. Improper
positioning may result in incorrect data collection.
IMPORTANT FOR ACCURACY
The following conditions may cause incorrect reading
of steps taken:
1. Uneven walking pace, such as walking in crowded
areas or on uneven floor.
PE830_EU_M_EN_R1.p65
2006.8.16, 4:47 PM
3
