EN
5
each sensor.
To setup your remote sensor:
1.
Place the remote sensor as close as
possible to the base unit.
2.
Remove the battery compartment cover by
using a Philips screwdriver to loosen the
screws, and then insert the batteries. (Be
sure to match polarities as shown).
3.
Assign channel numbers 1, 2, or 3. If you
are using more than one remote sensor,
select a different channel number for each
sensor.
4.
Select the temperature measurement units
°C or °F (Celsius or Fahrenheit).
5.
Press the
RESET
button with the point of a
blunt object (such as a ball point pen).
6.
Replace the battery compartment cover.
Secure.
7.
Position the remote sensor using either the
stand (included) or the recess hole on the
back of the sensor.
8.
Connect the adaptor to the base unit, press
and hold
TEMP
on the base until the
CH
icon
blinks. (It will take 3 minutes for the base to
search for available remote sensors even if
you only have one sensor).
9.
Once the batteries are in place, the sensor
will transmit signals every 40 seconds.
NOTE:
The readings shown on the base unit
depend on which remote sensor (1, 2 or 3) is
selected.
CHANGING THE REMOTE SENSOR
CHANNEL
To change the channel on your remote sensor,
select a different channel number and then press
RESET
on the sensor.
To install the battery in
your handset:
1.
Open the battery
compartment cover
located at the back
of the handset.
2.
Plug the battery
connector into the
socket.
3.
Replace the battery
compartment cover
by sliding it in the
direction shown by the
arrow in the diagram to
the right. The cover
clicks into place when
it is secured.
BATTERY SETUP
CHARGING HANDSET BATTERIES
You must charge the handset batteries for 15
continuous hours the first time you use them.
When the icon appears empty and “CHARGE
BATTERY” shows on the LCD screen, or if you
hear a warning beep during a call, please:
• End the call as soon as possible.
• Charge the handset by putting it back on the
base cradle with the keypad facing outwards.
(The blue
CHARGE
LED on the base unit
steadily lights to indicate that the handset is
charging).
NOTE:
It is normal for the handset and base to
get warm when the handset is charging on the
base.
TEMPERATURE UNIT
The temperature display switch is located on the
bottom of the base unit. Use the tip of a pointed
object (such as an unfolded paperclip) to switch
between Celsius and Fahrenheit. The unit of
measurement should match the unit you selected
for the remote sensor.
NOTE:
When the outdoor temperature reaches 40
1.
2.
3.
TW339 manual_Eng 6.p65
3/9/05, 4:21 PM
8
