3
EN
THE BARO-THERMO-HYGROMETER
The baro-thermo-hygrometer measures the atmospheric pressure,
temperature and humidity.
The sensor uses four UM4 or “AAA”-sized batteries.
To install it,
1. Insert alkaline batteries accordingly.
2. Mount the unit where you want to monitor the readings. Or you
can make use of its table stand to place it on a flat surface.
THE MAIN UNIT
The main unit gives you all the readings and controls. It should be
placed indoors.
The main unit is powered up by the 12V AC adapter.
To install it,
1. Position the main unit and other units within effective range
(100 meters).
2. Insert four UM4 or “AAA”-sized alkaline batteries for backup
purpose.
3. Mount the main unit safely in place. Or use its docking bracket
to place it on a flat surface.
4. Connect the AC power adapter to the main unit and a wall socket.
5. Press the [RESET] button on the main unit to initiate operation.
The main unit will start searching for signals for about four minutes.
Upon successful reception, the readings will be displayed. The main
unit will update the readings at regular intervals.
TABLE-STAND
A docking bracket is provided so that you can rest the unit into it as
well as for placement of the Stylus provided. The Stylus is designed
to facilitate the touch-screen operation but you can also operate this
function simply by touching the screen with your finger.
Caution: Do not press the screen too hard with the Stylus or it would
cause damage to the display.
LOW-BATTERY WARNING
There are low-battery indicators [
] for the main unit, rain gauge,
baro-thermo-hygrometer, thermo-hygrometer and optional remote
thermo and thermo-hygro sensors. Replace the batteries when the
respective indicators light up.
Note: The readings collected from the thermo-hygrometer and any
optional remote thermo and thermo-hygro sensors share the same
display window. The “OUT” and remote channel will share the
same low-battery indicator. When the battery level of the thermo-
hygrometer is low, the low-battery indicator will turn on. If it is one
of the optional remote sensors, the low-battery indicator will blink.
To locate the channel in question, press the window to scan through
all available devices. The low-battery indicator will stop blinking if
the battery level is low for that one.
DC 12V
Stylus
Docking bracket
WMR112_EN_output
9/1/04, 7:04 PM
3
