ORGAPACK OR-H 47
Fig. 4
– When the strap tension is reached,
move sealing lever (Fig. 4/1) to the
stop.The right hand remains on the
tensioning lever to resist the oppo-
sing force. The strap is sealed and
cut.
If the strap cut is incorrect (see
chapter 6.2).
Fig. 5
– Return sealing lever to initial position.
– Raise the rocker lever against the
sealing lever.
– Swivel the tool away from the
strapping backwards and to the
right.
Fig. 6 Seal check
To obtain the maximum seal efficiency,
the notches must be cut and interlo-
cked properly into the straps: Check
this regularly. If these notches are not
correctly cut, replace die and tension
plug (see chapter 6.3).
ca. 1 mm (.039")
Fig. 6
Fig. 5
.
Fig 4
.
1
09/07
Page 5 of 7
